MVBInfo.com > Sail Flaking Systems > Sail Flaking System Layout Form (print & fax form)

Sail Flaking System Layout Form
Please complete this form and click submit. Or, print & fax to us. We will design the layout and fax it back, usually within 4 hours, or send it with the system. We prefer all dimensions to be in decimal feet, but can work with metric dimensions or feet / inches.

By when do you need this layout? Date?  Time 

1.
Measured Luff
Measured Foot
Boat
Size
Year

2.
# of control lines planned  
 More lines cost more, work better.

3. Spreader lengths
spreader 1
spreader 2
spreader 3
spreader 4
  Measure from center of mast track to spreader tip, for each spreader. Ways to measure spreader lengths;
1. Look for marks on the sail
2. Tape a yardstick to a halyard with a downhaul line.
3. If a single spreader rig, the lower may run fairly parallel to the mast. Measure at a few points to check.
4. Check our database in Tech Manual. Accuracy not guaranteed - use as a double check.

4. Luff hardware measured from the tack. Run a measuring tape from the tack to the head. Record the positions of all the luff hardware. We can work from the head down, but foot up is much easier for us.
For a Slide, type "S" and the measure
For a Batten, type "B" and the measure
For a Reef, type "R" and the measure
1
2
3
4
5
6
7
8
9
 10
 11
 12
 13
 14
 15
 16
17
 18
 19
 20
 21
 22
 23
 24
25
 26
 27
 28
 29
 30

5. Batten length, leech position measured from the head, leech length. Run a tape from the Headboard down the leech. Record the leech position of the battens. Note the Leech length. Then measure the length of each Batten. Lengths of short batten are not needed. If there is NO chance short battens will ever be converted to full length battens, write NO under the length for short battens.
Batten 1
Position
Batten 2
Position
Batten 3
Position
Batten 4
Position
Batten 5
Position
Batten 6
Position
Batten 7
Position
Leech
Position
Batten 1
Length
 Batten 2
Length
 Batten 3
Length
 Batten 4
Length
 Batten 5
Length
 Batten 6
Length
 Batten 7
Length
 Leech
Length

6.
Mid-Point Girth
 
If not a full batten sail, from center of luff, measure from the luff to the leech. Keep tape 90 degrees to the luff.

7. System Information
System
System Type 
Monofilament Needed
Shipping Method

Number of Control Lines


8. Contact and ordering info.
Name
Loft / Company
Address
City
State
ZIP
Tel
Fax
EMail